very nice job

Bought my 900 via a third party as a part started kz900c to A4. I ordered a hf401 filter (paper type) from dave, however when removing the old filter it is the taller metal canister type. Which leads me to wonder if the engine is not prehaps the original, the barrels are marked 903, the engine numbe...

Sweet

Ahh phillipe you have done it again. That is what I would like to try next ... will-be looking forward to this

ZedHead wrote:It looks like it could be for rear mounting caliper that has found its way onto the wrong bin. I checked your orders and you can eliminate me from your list of suspects

Ha ha.

I bought them as a set but cannot remember from where but they obviously messed up

Here they are side by side Or is this correct ? It dose not look right

Bought a set of brake pipes ages ago when I was collecting parts. Now at the point of fitting the dual set up on the a4 and notice one does not look correct picture below"... anyone have an idea what this is for The other one appears correct for the right side but the left one below (Speedo dri...

how did that happen my head is going to hurt

been a while since i posted due to trials and tribulations with the front end and then a holiday.

Finished the mounting of the rear mudguard and light



small progress but progress never the less, onwards and upwards,

The fork leg bottoms are different on the z900a4 and z1000a1 to the z1000a2 a slight difference that will not allow a2 callipers to fit in a forward facing configuration, this was not a plan I thought I had a4 legs A5B7E97D-207B-468F-A2A3-86D76499402C.jpeg The a4 and a1 are on the left and the rear ...

It was time to bite the bullet and give it a go 0A588D7E-B702-4467-9359-C7A64A413B12.jpeg Filled the stud hole with releasing fluid and covered over and repeated for a few days F591ACEF-F76C-4CCD-943F-807EA87FCBD1.jpeg Centre punch C22D57A8-9149-45CC-ACFB-B0C4CC135553.jpeg 2.5mm pilot hole B8A0901C-...

Ditto lovely paint. I had a c2 silver blue nice standard. Condition looking forward to seeing the progress

Unfortunately it had snapped flush so it will need to be drilled and helicoiled

I will keep plugging Away not going to give up

Very nice welcome onboard