stems seals gone as well,but i have these.

just wanting a set of std rings/top end gasket set

Took head off on Thurs night.
Took barrel to my local engine m/c shop to be measured .
His recommendations are,Barrels are ok
Hone the barrel
Fit new rings.
Wheres best place for a top end gasket set
Set of std piston rings please.

Thank you for that. Don't know exactly until the head comes off then i can get them measured up at my local engine building company. The compression test was conducted when the engine was hot,throttle wide open. each cylinder read 70psi. Know for a few years now one day i would need the stem seals d...

Taking the head off in a couple of weeks,so i don't know for sure. Just getting a idea of cost.
But what do know now is
When starting up from cold the bike smokes a lot,then disappears when warm
Compression tests so an even 70psi per cylinder

Doing a rebuild in the next couple of week and looking for the above.
Been comparing prices on ebay,power etc.
Any tips guys when buying the above.
I know i need quality items.
What gasket sets are good,same question for pistons.
Been told imd pistons are good,anybody else agree with this ?

thanks

Seen a lot of discussions about stem seals and gasket sets. Normally buy from zed power,but some items can be very expensive. Looking at a top end rebuild new pistons,rebore,valve stem seals. Seen these on ebay Kawasaki Z900 7mm Viton Valve Stem seals set of 8. The best! 362100452380 are these any g...

Wheres the best place to by pistons (what make)
gasket set
Valve stems etc.
I know about Zedpower.
The prices for these items vary,i don't want to use ebay.

How do i get in touch with Zed1015

Im wanting a good Z1 engine builder please in the south yorkshire area,if possible. My 73 Z1a as always smoked abit,but over the years its got worse,i know its burning oil a bit. Did a compression test,only got 70psi. So I'm thing i my need a top end rebuild,rebore etc. may be carbs balancing as wel...