Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Search found 5 matches
- Wed Aug 31, 2022 3:13 pm
- Forum: Bike Help
- Topic: Chain & sprocket wheel alignment
- Replies: 3
- Views: 798
Re: Chain & sprocket wheel alignment
Cheers for your help & confirming what I was led to believe. I have ordered a 16mm offset 18T drive sprocket, 42T rear sprocket & chain from Suzuki racing. So I will get the carrier hub machined & hopefully sort that problem out. I have another issue that I could do with some help please...
- Sat Aug 27, 2022 12:30 pm
- Forum: Bike Help
- Topic: Chain & sprocket wheel alignment
- Replies: 3
- Views: 798
Chain & sprocket wheel alignment
Hi all, Would appreciate some assistance with the following please.:- I am customising a 1980 KZ1000G which was imported from the states & have made some changes to the front & rear of the bike. I have fitted a Bandit front forks/wheel & 1200 swing arm, along with a 5.5 inch wheel & ...
- Sat May 29, 2021 8:44 am
- Forum: Bike Help
- Topic: Gear selector rebuild
- Replies: 3
- Views: 943
Re: Gear selector rebuild
That makes sense now.
Thanks.
Thanks.
- Thu May 27, 2021 11:50 am
- Forum: Bike Help
- Topic: Gear selector rebuild
- Replies: 3
- Views: 943
Gear selector rebuild
Help required. It's been ages since stripping this Z1000G motor and need guidance re correct location of the gear selector pins. The copy of the manual I have specifies the location of the longest of the pins but the picture isn't clear as to which hole it is. 7 hole and 6 pins ?? Also can anyone co...
- Thu Jun 18, 2020 7:37 pm
- Forum: New Here?
- Topic: KZ1000G project
- Replies: 7
- Views: 3998
KZ1000G project
Hi All, I'm new to the forum & would appreciate some advise please I have purchased a KZ1000G - circa 1980 USA Import as a project. I have already stripped down the engine & most of the frame & basically have a blank canvas to work with. The question I have for now is on what modern day ...