Thanks Warren, plenty of choice.
Can’t recall if the fuel line internal is 6 or 8mm as there appears to be a choice to be made.
Any recommendation as to sourcing fuel line splitters?

Thanks for the advise.
Ideally locking for one that is serviceable.

Could anyone recommend a suitable type for my Z1B 900 ?

Thanks Kev, I’ll check them out.

Can anyone recommend a decent fuel tap (to suit a Z1b tank )other than the replica ones of which I’ve now gone through 2. Basically they don’t seal off completely.
Thanks

Hi from Kent England.
Very nice pair of Zed’s.
Must bring you a lot of joy.
I to have a Z1b in the same Blue & Gold.

Popping exhaust now resolved.
Air fuel mixture adjusted via Colour Tune.
Now running sweet as a nut.
Thanks goes out to Warren3200gt who helped with this.
Happy days ahead, once it stops raining.

Thanks for the Webb site details Warren.
Just to say I sent you a private message earlier, did you receive.

Thanks all, I take it there sourced via the Webb or is there a particular stockist you could recommend

Hi all,
Could anyone recommend a suitable alternative to NGK’s ( B8ES ).
Thanks

Hi Zapo, Again thanks for your advice, your right the coils are shared and have carried out all the checks that you mentioned. There is one other thing that I’m unsure about. When checking the ignition timing using my multi meter set on circuit continuity ( Buzz tone) so one connection to earth &...

Hi Kev Edwards,
Thanks for the advice I’ve released the exhaust clamps and repositioned the Half shells and bolted back up.
Unfortunately got no petrol to test out.
What’s going on?

Hi all, just reconditioned engine and overhauled carbs new manifolds new plugs leads cap coils condensers the full monty. The centre exhausts only are randomly popping independently of each other on tick over. It’s fair to say the popping is not frequent but occasional. Air screws initially set at 1...

Hi DogsbolloxofZ1B,
Thanks for CMS details, unfortunately there out of stock at the moment.
Atb.

Hi all, does anyone know where I might get hold off tab washers for the carbs?