John browse , the kwaker parts guy in Wrexham does resleeving.

ZEd1015, I wasn't suggesting you ( or anyone else ) had copied and pasted or Googled. Apologies if you got that impression. I agree with you and now use almost any 10/40 semi=synth I can get hold of. After rebuilds, I recommend people run on mineral oil to ensure good bedding in. My experience of st...

I'm not an oil expert, and don't profess to be. what I can tell you is this : Over the last 15 years, I've restored and run 6 Gs1000's, a CBX, Z1300 , both Benelli sixes, Z1a, Z1r , Guzzi Lemans 3 and a few others I cant remember. I tried Mobil 1 fully synth in nearly all of them ( bought a drum of ...

No 864, complete with box and certificate.

In excellent condition, only worn a couple of times for VJMC club meets.

£275 , price includes new battery fitted and insured Uk mainland postage. Payment by BACS only.

If you prefer to collect and inspect, I'm in Southport.

Loz

too late Reecy, or should I call you Tracy from now on ?

Grease gun as Paul said. Put the caliper back together if split, put pistons back in and clamp the free ones. Block the fluid inlet with washers and the banjo bolt, then apply a grease gun to the bleed nipple ( opened of course ). Grease gun can apply massive pressure, and when a piston comes out, y...

Thanks Paul

Can someone kindly tell me what the big K manual says. It is going to be a figure like 3.5mm=/-1mm.

Thanks

Loz

Thanks Mark. all useful info gratefully received.

many thanks. I sorely regret letting my workshop manual go when I sold my Z1A.

could someone with the genuine Kawasaki workshop manual kindly tell me the correct code for the needle jets on the A4 carbs. Then I can order new ones from Allens before removing the old worn ones.

Thanks in advance

are you sure that you are not suffering with slightly more seal stiction than usual in the calipers, especially with the pistons being stainless rather than chromed finish ? I have experienced this before with stainless pistons. It can show up as the calipers having slack on the discs which you can ...

Dave, BF, I'm still here. Might have set of clocks of sorts. will check and post here tomorrow.

Evening all, trying to overhaul a set of 28mm Z1b type carbs a mate bought from a well known spares supplier but they have turned out to be a right mess. Most of the probs sorted now, but one of the choke pickup tubes has been mangled and the end split off. This is the small brass tube which protude...

erm....where wot ? .......the clue might be in the thread title......