Hello Guest User,

Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.

To access these 'Registered Users Only' areas simply register and login.

Search found 3103 matches

Author: z1bman
Tue Jun 19, 2018 10:55 pm
Forum: Bike Help
Topic: Gasket sets
Replies: 2
Views: 55

Re: Gasket sets

most genuine gaskets are still available if you want to save money buy cheap aftermarket but you cannot buy better than original if you can get them
Author: z1bman
Mon Jun 18, 2018 7:15 pm
Forum: Bike Help
Topic: A4 air box
Replies: 9
Views: 145

Re: A4 air box

yes they are the same part no 11011-054
Author: z1bman
Sun Jun 17, 2018 3:25 pm
Forum: Bike Help
Topic: z1 900 starting probs
Replies: 25
Views: 756

Re: z1 900 starting probs

you must have a problem with the yellow/red within the harness it splits into two wires to feed both coils. also pull on the yellow / red that comes out of the harness & into the block connector there might be a break in the wire where the terminal is crimped in the block connector. also check t...
Author: z1bman
Sun Jun 17, 2018 1:28 pm
Forum: Bike Help
Topic: Ugly centre stand.
Replies: 7
Views: 142

Re: Ugly centre stand.

yes it will make it extremely difficult to put it on the stand & you could end up having an injury or even drop the bike
Author: z1bman
Sun Jun 17, 2018 12:33 pm
Forum: Bike Help
Topic: z1 900 starting probs
Replies: 25
Views: 756

Re: z1 900 starting probs

yes that is correct so that proves the switch is ok
Author: z1bman
Sat Jun 16, 2018 4:19 pm
Forum: Bike Help
Topic: z thou rear disc brake pads.
Replies: 12
Views: 176

Re: z thou rear disc brake pads.

57.6 x 52.8 x8mm
Author: z1bman
Fri Jun 15, 2018 10:15 pm
Forum: Bike Help
Topic: Z900 Valves
Replies: 3
Views: 111

Re: Z900 Valves

I was just removing the valves from a z900 head and found an additional shim under each of the lower valve spring seats. The shims are all stamped VSI and 203. Please see photos of the item below. Can anyone lets me know anything about these items as they don't appear to be listed in the parts manu...
Author: z1bman
Fri Jun 15, 2018 9:17 pm
Forum: Bike Help
Topic: Fork springs
Replies: 3
Views: 85

Re: Fork springs

top one is correct for z1b the bottom one is an after market replacement valve kit but its assembled wrong in the photo
Author: z1bman
Fri Jun 15, 2018 8:19 pm
Forum: Bike Help
Topic: z thou rear disc brake pads.
Replies: 12
Views: 176

Re: z thou rear disc brake pads.

the a1 uses the hollow type piston the one with the heat sink disc is only used for bikes that use sintered metal pads which are not as thick as normal pads
Author: z1bman
Fri Jun 15, 2018 11:08 am
Forum: Bike Help
Topic: z thou rear disc brake pads.
Replies: 12
Views: 176

Re: z thou rear disc brake pads.

what model z1000 is it ?
Author: z1bman
Thu Jun 14, 2018 9:39 pm
Forum: Bike Help
Topic: z thou rear disc brake pads.
Replies: 12
Views: 176

Re: z thou rear disc brake pads.

are the pistons hollow or do they have a heat sink disk pressed into the piston ?
Author: z1bman
Thu Jun 14, 2018 9:30 pm
Forum: Wanted Adz
Topic: Z900 A4 air box
Replies: 5
Views: 203

Re: Z900 A4 air box

good luck with that one :D :D
Author: z1bman
Thu Jun 14, 2018 9:27 pm
Forum: Bike Help
Topic: z1 900 starting probs
Replies: 25
Views: 756

Re: z1 900 starting probs

yes they will be ok
Author: z1bman
Thu Jun 14, 2018 8:37 pm
Forum: Bike Help
Topic: z thou rear disc brake pads.
Replies: 12
Views: 176

Re: z thou rear disc brake pads.

have you got enough free play in the actuator rod between the lever & master cylinder? is there too much fluid in the master cylinder ? does it free up if you slacken the wheel nut ?

Go to advanced search