Hi .
Here's the link below I believ. As its in the HOW to section you have to be a PUM to view.

viewtopic.php?f=22&t=2588

Ive heard good things about this one as well.
viewtopic.php?f=56&t=47900

Chas Mortimer.

Have you checked the pick ups in the points housing ? My dyna packed in last year after 18 years of working without an issue .If there are signs of it over heating, the plastic cover expanding then it could be fried .Measure the voltage at the coils it should be at least 12v.

Power transistors ?
https://www.cnczone.nl/viewtopic.php?p=261164
http://livinginthepast-audioweb.co.uk/i ... ign-rb.php

I've used these in the past.
https://www.cruzinimage.net/2018/06/12/ ... el-pipex2/

Hi, Was the oil specific to motorcycles or the generally available Castrol semi for cars ?
Car oils contain friction modifiers which will cause clutch slip on a wet clutch .
Cheers Colin

Looks like its 4-5Kg-m 29-36ft lbs on the 1000 which is the same.
https://www.dropbox.com/s/kryzwr5to2m4d ... lyprep.pdf

Hi Deka, I believe you need to put a price on items for sale.

Try searching in the tech help section. Most things have been asked / discussed before.
viewtopic.php?f=4&t=46641&p=386955&hilit=wiring+loom+routing#p386955

You will struggle to get the rear sprocket off the shelf in the UK.
I got one earlier this year from Redline Cycles in the US.
If you email Jim he should still have one.
Not cheap though

http://redlinecycle.com/ocindexmain.html
jim@redlinecycle.com

Hi Stephen, not a ZRX but closer to a GPZ900 and closer top your door
https://www.gumtree.com/p/kawasaki-moto ... 1446693195

Hi . No the nuts should not be moving the clamps should hold the Sleeved part of the nuts still. As mentioned earlier there should be a notch in the speedo drive which locates into the fork leg . The only parts that should be moving are the front wheel and the internal gears for the speedo drive ass...

It would appear your speedo drive casing isn't located correctly .I'm sure it should use the fork leg to hold it in place and the cable drive should come out parallel to the ground