I also just found out that what I thought was a complete system for that price isn't. You have to pay an extra ,135 euros for the link pipe, clamps and heat shields. Tha whole deal is a total rip off. There customer service is atrocious, sometimes they reply mostly not. I have asked several times fo...

Has anyone had any dealings with basso silencers. I ordered a set of Z1000 exhausts for my 77 on the 1st December 2022 the said delivery would be February. February came ant went and nothing I contacted them to see what was happening and was told the end of March eventually I got a text from DHL on ...

Looked in the FSM but can't find any photos showing the positions.

Hi I was wondering if anyone with a 1977 Z1000 A1 could take some photos of the warning decals position's and post them as I can't find any photos of where they go.
This would much appreciated
Thanks

Just done my valve clearance Z1000a1. Fitted a new gasket (aftermarket) put the cam cover on and the camshafts are hitting the cover and lifting it haven't had this before. Has anyone else had this happen and what did you do.
Thanks

Has anybody experienced this. I bought an aftermarket air filter from Z power but it is to long for the filter housing and I can't get the top lid to fit. The part number for the air filter housing is for a Z1000. Are the Z900 filters the same. I've bought aftermarket filters before when I had my Z1...

Thanks for the reply
It's just I got a set of Z900 ones from a friend but the bolt holes are 6mm and I need 8mm for my Z1000. So if they fit all I need to do is drill them out to 8mm and that will make them fit my bike. But I will also look into the ones at Z power
Thanks again

Can anyone tell me if the Z900 exhaust flanges with the 6mm bolt holes will fit the Z1000 if i were to drill the holes out to 8mm as they look the same and there looks like there's enough meat on them to drill them out.
Thanks

Thanks for that Kev
The thing is they show both the screws on the same parts diagram, on CMSNL thats why I was asking and I found a place that sells them for 8 Euros a piece but wanted to be sure before I bought them.

Can anyone tell me if these mixture screws are the same size.
I have a set of VM28 carbs with the screws without the O ring but want to change them for the ones with.

I've got a 1977 Z1000 a1 fitted with vm28 pumper carbs but someone has removed the accelerator pump diaphragm and the small check valve inside the float bowls. I know I can buy the diaphragm from NRP but do I need to fit the check valve as well and do I need to fit them too the other bowles as well....

It snapped in half with most of the bridge on the left side
Head is off the bike

Has anyone got a No3 cam bearing cap they would be willing to sell as I just broke mine while tightening down the cams, not paying attention doh!.
Hope someone can help me out thanks

Thanks Ultim8pc I always wondered where that rubber band went

Can anyone tell me where the brake light failure relay mounts on a 77 Z1000
And where does the overflow pipe clamp gos. Photos would be a great help.
Thanks