Thanks

Anyone know how the plastic wheel comes off the trip recorder spindle,? Trying to fix my bent one but can’t see how to remove it without destroying it,,,,
Bikes a 1976 Z900,,

I remember reading an article on grant saunders setting up as a motorcycle manufacturer on his own, Bike magazine early eighties I think,, yes he did work for Harris for a while,,,,,,
Could try a custom frame builder for repairs,,Brill maybe at custom cycles.

First job on the long list is to get the Yamaha XJR1300 swingarms in. The original Zed spindle and pivot hole should ideally be 16mm but in actual fact the hole is 16.2mm and the spindle is 15.8mm so a massive 0.4mm slack fit that translates to much more at the rear wheel end which doesn't do the b...

Oh whoops,! Thanks for that,,I did look through the list at Zpower but couldn’t see it so assumed didn’t keep it,,
Guess I should have asked,
Cheers

Thanks for help,, but I made a boo boo ,,not the inner spacer ,, it’s the outer shouldered one that I need ,,

Trying to reassemble my rear wheel after fitting new bearings,,and the spacer which goes in between the bearings has gone awol,,!
Can anyone tell me measurements or better a pic and measurements,,,,pls
Bikes a 1976 Z900 with spoked wheels,,,?

Cheers for help,,

Do the footrest support pins that go into the frame that the footrests themselves sit on screw into the frame,,? Or do they just push in and can be drifted out from rear after removing the nuts,,
Bikes a 1976 Z900,,

Hi, I took the float bowls off my 82 z1000 ,CV carbs and sandwiched between float bowl and body are small rubber/neoprene discs ,,no holes in em and they sit in circular casting on top body and on gasket on float bowl,,,one of them is missing, so I wondered if it was necessary,? There are no drillin...

Very,very nice
Where did you buy the rotabroach cutter from,?

Thanks everyone,,,,I’ll check em out,,

Bit of an odd one this,, on my 76 Z900 the rubber holders the speedo +tacho light bulb holders sit in have perished and disintegrated,,,,look like well chewed winegums,,,
Does anyone know where I can get some replacements/alternatives,,,,,,tried vehicle wiring products etc ,,no luck,,
Ta,

Hi can anyone post a pic of the wiring harness route past the headstock to the headlamp on a 1982 Z1000 CSR,,?
When I got the bike the harness hangs down at front under the bottom yoke then up ,,,,,ugh ,,can’t be like that originally,,,,,can’t find any pics,,! Thanks