Pipe worked a treat, just had to nip about 1/4 inch off the larger diameter end....happy days!
Think I will stock up with a few more

...Leave points cover on. the roll the engine over onto the 8"x2" square piece under clutch cover, then place a piece of 4"x2" under the fins. Holds the engine square. No need to raise it off the floor any higher as this gives you plenty of room to install the rear lower bolt, th...

Thanks Al, its quite a short tube so a joint might be tricky.

I found a 11 - 7mm reducer pipe for a VW sirocco which may fit so i ordered it. Ideally it should be 12 - 8 I think....lets see

I saw those pipe on ebay, they are silicon pipes which i dont think you can use for Fuel!

Rob

I am looking for the small fuel tube between the pump and the filter on my Gpz1100. Bit difficult to find!. The tube is larger diameter at the fuel pump end than thee filter end. Its about 12mm to 8mm at a guess. Its the same set up as the H. Question does anyone know if I can get a rubber fuel tube...

You need two people, if the frame doesn't hit the rear of the engine dead square it wont locate......

the reserve on the DK one is about 23.5K...sticker price in the showroom is 25k

I have an Alpha, which exits on the left in good undented condition

Usually I remove the cam cover and exhaust studs, roll the engine on the side so the clutch cover rests on a piece of 8x2 timber, and slide a piece of 4x2 timber under the cylinder head fins; holds the engine exactly right!. Its a two man job really, you need to locate in the bottom rear mount first...

They seem a bit scarce for some reason. Ironically MidValley Kawasaki in the states messaged me to say they had one.
I am sorted, maybe try john Browse Ian

Cheers

Rob

PM responded, please send the pictures
Thanks
Rob

Does anyone have a uri spec cam cover (no emission valves) that they would part with please. It’s for an 83 unitrak
Thanks
Rob

sorry sold

Hey Will, do you have to bend out the brake pedal a bit to use that clutch cover extension???

Rob

Any suggestions what these are from, not z1000
Thanks
Rob

Bravo Sir!.....but I think I would get one off Rob