I searched hi n lo to find a diagram with the override switch plate and switch. No diagram I found showed it. I only ever found diagrams as shown below without the switch. I spent several hours fitting and refitting the additional plate and spring before I finally sorted it to work as I described pr...

Looks like a j/elr tail light.
White looking small ones above are hi vi's red leds

Pm's do not show as sent until recipient opens them.

That's an earlier oval tail light version.

Nothing wrong with Keyster kits Graham. Sorry not from my experience :sad jets I am talking about , genuine Mikuni every time . Each to their own . I'm talking Keyster jets (which are in the kits) I've used probably 40 - 50 Keyster kits over the years and never had an issue. If I were just replacin...

Nothing wrong with Keyster kits Graham.

Z1 - Z1B shaped to fit the oval tail light. Z900A4-5 shaped to fit the more rectangular tail light which was also used on the Z650 and Z1000

Doesn't matter which to which.

Doesn't raise anything. Just preloads the forks so that they don't dive until the preset load is exceeded in my experience.
I put about an inch of pre load in my 650's and 900 & 1000.
I do like a stiffer front end and hate the fork dive of soft forks when braking.

Looks like emissions plate so probably go a hole under the 10p to block it off ?

moizeau wrote:What a difference a hole makes.

Yep, difference between being in the pink or in the shit

There you go Graham. Reputable member / seller.
https://www.facebook.com/groups/z1owner ... 263828370/

Ah OK, my J2 side stand uses the same mount bracket along with a seperate sprung loaded plate to operate the stand kill switch. It's quite a clever set up. The bike will start on side stand but unless the override switch is depressed as you lift the bike upright the stand will spring back about 15 d...

Have you guys got this side stand override kill switch on your bikes? Red one next to the hi lo

If you zoom right close on your picture there is a different coloured area central on the LH hole. Looks like it's rusted up. Get probing!