F**K what everyone thinks GB, I think you should put Nitrous on it. No point in fooking around. Buzzard.

Need a front wheel hub 6 bolt disc type for Z1B. Buzzard

measured wire diameter on springs with vernier same all the way through, i dont think it matters what way they go. ive never worried what way round they go, never had any problems. buzzard.

Not sure what paint is. Got some new APE springs here no paint so could go up any way. Don't think it matters but might be wrong. Sorry not much help, Buzzard.

Anyone know if you can get some sort of replacement plastic cover for the choke lever? Buzzard.

Ginger bear, Engine sounds good, must be that top notch cylinder head work you had done. What ignition settings have you set? Dyna 2000? Buzzard@'buzzworkz.

Thanks for the info lads. Buzzard.

Anyone out there got any info on regulator/rectifier all in one units, which ones are anygood? Where to buy one? Thanks Buzzard.

Standard Z900 lump, wouldn't go larger than 29mm, anything else is a waste of money. Didn't one of the Z1R models have 28mm carbs with accelerator pumps?? Buzzard.

Inlet 91.70mm. Exhaust 90.30mm. Buzzard@Buzzworkz.

Bike looks very nice, very good standard of work. Buzzard.

Whats up with your head, most things can be repaired. Buzzard.

Wayne, I did say it would smoke and I advised you it would need a rebore. If you remember number 2 cylinder had damage to bore from the metal F.O.D incident, also number 1 cylinder had a bad score along the length of the bore and number 4 cylinder had a bad rust/ water stain mark aswell. You need to...

Going on Saturday, looking forward to it and a bit of a chat. Buzzard.

15t front x 35t rear sprocket on Z1, Z1A and Z1B's, this give a final drive ratio of 2.333. 15t x 33t sprockets on Z900 and Z1000, this gives a final drive ratio of 2.200. 18t x 40t sprockets in 530 chain would give a final drive ratio of 2.222 which is the same as your Z1000 setup. A smaller back s...