Make sure the shaft that links the cold start plungers is not bent and they are all dead in line,i had the same prob with my A4,would lift out one at time but not together cheers PaulJ....

Try using a Gunson Colortune tou can see inside the combustion chamber saves a lot of guesswork.....

If the tanks have a prime position try runninig on that,also has the fault occured since you fitted filters?if so thats probably the fault not emough flow if no prime on yout tap rig up temp feed from another source and see if prob clears in my experience vac taps are a pain Cheers Paul J..

Nice to see H****s have some use is the unit the same as the one i recomended from the wet dream series??

Yes good meet apart from losing my sat nav on route ,notice z1000 steeering damper haso only one nut holding it on!!!!!!!!!! only joking PJ,was really good to meet all there Cheers Pauljac......

Coming over from Wolves Sunday with paulstrees cant make my mind up to come on the a4 or Z1b?

Sounds like a poor earth to me,check batt volts also 1,2 volts per cell,make sure all lamps same wattage, cheers Paul j..

A Superdream unit works fine 250 or 400 get a good secondhand one Cheers Paul J...

Hi fully advanced by 3k sound about right.pinking as i have always understood is when fuel ignition is retarded.you have set up gaps on points if you still have them fitted to 14 thou at F for 2 and 3 and 1 and 4 pot I take it,try advancing ignition timing slightly to see if matters improve or get w...

Bad Luck mate,you probably wont get enough heat with butane you could try Mapp gas but as you have found is a bugger to get hot enough guy who could help you on this is Marallan one of Mikeys mates in Bristol send him a PM friendly guy who helped me out Cheers Paul j..If all else fails i have an exc...

Hi Alan try to get a Gunson colortune (halfords)this is invaluable for setting correct mixture as you can see ignition flame in engine,sound like you have probs with pilot settiings to me! you would see this straight away with a colortune and any other jetting mix problems as you increase revs,have ...

Get some silicon spray like dashboard cleaner put rubbers into a plastic bag fill with the silicon spray and leave for a couple of days with top tied this sometimes works quite well Cheers Paulj..

Hi All just found out the Nos rear sprocket i was going to fit on my project Z1b is a 33 tooth item what would be advantages/disadvantages against standard 35 tooth item?

See my post on this for extra info still got one sooty plug no matter what i try!!! Will watch this post with interest Cheers Paulj..

Hi John there are a number a carbs that would fit your bike including Suzuki Gs,but you may end up with more problems,be more specific with probs you are having,if you have fiited standard jets,needles etc should just be a matter of correct settings,mixture,balance,ensuring correct amounts of fuel b...