Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
REDUCED! :wiseco 1075 conversion
Moderators: chrisu, paul doran, Taffus, KeithZ1R
-
8 Valve Mark
- Custard Cream
- Posts: 966
- Joined: 3rd Nov 2016
- Location: Glasgow, tropical west Scotland
REDUCED! :wiseco 1075 conversion
1015 barrels,(72mm forged pistons@10.25:1cr)with new wiseco liners, professionally fitted, bored,piano wired, and honed:, wiseco forged pistons, rings, pins n circlips..only 1,100 careful miles under 6,000 rpm.ASSURED.one v. v. very small chip to 1rear fin which is almost invisible.fit n forget..all in; about £1100 cost including purchase,import duties, shipping n machining etc.£650 + post.no offers thanks pm/email for pictures, info etc. cheers m
Last edited by 8 Valve Mark on Sun Aug 04, 2019 1:00 pm, edited 2 times in total.
-
8 Valve Mark
- Custard Cream
- Posts: 966
- Joined: 3rd Nov 2016
- Location: Glasgow, tropical west Scotland
Re: wiseco 1075 conversion
REDUCED! on behalf of the owner:£550! plus p+p!! bargain for the cost of the pistons alone. m
Last edited by 8 Valve Mark on Sat Jun 08, 2019 9:52 pm, edited 1 time in total.
-
trikerdrew
- 100Club
- Posts: 221
- Joined: 30th Nov 2007
- Location: leicester,uk
Re: REDUCED! :wiseco 1075 conversion
will these fit z1000J?
drew
drew
-
neilbarrett
- ZedHead
- Posts: 1179
- Joined: 25th Feb 2008
Re: REDUCED! :wiseco 1075 conversion
sure the small ends are different sizes on the conrods ?
Re: REDUCED! :wiseco 1075 conversion
1015 barrels won't fit the 998 J without modification for the slipper tensioners..
You could use the pistons as they are the same 17mm pin but the pin sits higher in the earlier 1015 pistons than the J and the 1015 block is taller so you would lose compression which would require a shortened J block to compensate.
You could use the pistons as they are the same 17mm pin but the pin sits higher in the earlier 1015 pistons than the J and the 1015 block is taller so you would lose compression which would require a shortened J block to compensate.
Last edited by zed1015 on Sat Apr 20, 2019 10:10 am, edited 1 time in total.
Re: REDUCED! :wiseco 1075 conversion
trikerdrew, you have PM.
Who is online
Users browsing this forum: No registered users and 31 guests