Page 1 of 1
Wanted - Z1A Cylinder Head
Posted: Fri Jun 15, 2012 12:39 pm
Author: IrishKev
Anyone got a Z1A Cylinder Head that they would sell. Need to complete the restoration of my Z1A and the last thing I need to find is a cylinder head. I have had no luck anywhere so I am hoping someone might have one lying around.
Regards Irishkev.
Posted: Fri Jun 15, 2012 2:41 pm
Author: 000zeds
Kev , Try John Browse M/C in Wrexham 0044 1978 355556
Posted: Fri Jun 15, 2012 4:43 pm
Author: jimmock
Kev,
I didn't think getting one would be that hard???
Jimmock.
Posted: Fri Jun 15, 2012 4:46 pm
Author: hillbilly
i have five cylinder heads here ,dont know what there off(900/1000)not sure about differences in them.
Posted: Fri Jun 15, 2012 9:57 pm
Author: Rob W
Got a Z1B one, its not a standard bore. Also the small screw that holds the cam tensioner blade in place came lose and has damaged its thread, will need refurb but apart from that looks nice no damaged fins.
Posted: Fri Jun 15, 2012 11:13 pm
Author: jimmock
hillbilly wrote:i have five cylinder heads here ,dont know what there off(900/1000)not sure about differences in them.
Exhaust studs will help identify them, 6mm or 8mm??
Jimmock.
Posted: Sat Jun 16, 2012 9:26 am
Author: Keefleaf
jimmock wrote:hillbilly wrote:i have five cylinder heads here ,dont know what there off(900/1000)not sure about differences in them.
Exhaust studs will help identify them, 6mm or 8mm??
Jimmock.[/quot
Also inlet port should have blanked off bit for adapters
Posted: Thu Jun 21, 2012 4:41 pm
Author: hillbilly
got two 900 heads.one 1000.one 650,the others been cut up on sectioned engine.the 1000 one has the dreaded crack between plug hole and valve seat.
.
Posted: Thu Jun 21, 2012 9:03 pm
Author: stempy
PM Padders he might have one
Rick