Z1OwnersClub GB

Just thought I'd ask here!

I need the following to fit the 4-2 exhaust to the Z1000R and before I buy some from CMSNL and pay a small fortune (nearly the same cost as the parts) wondered if there is anyone on here that might have them or could point me in the right (and cheaper) direction!

2 x 131J1055 10x55 black flanged bolt
2 x KA00204082 cup washer
4 x KA00219856 Rubber bushing

Thanks in advance

Have you asked on kz1000r.com

ADRIAN H wrote:Have you asked on kz1000r.com

I think that site is shut down unless anyone knows different.

I always use stainless studs and brass nuts.

Why brass nuts? Because they strip easier than the studs will

Unless you are going factory, in which case that is of no help,LOL!

drew