Page 1 of 1

Z1000 (1015) bare barrel WANTED any size...

Posted: Mon Mar 13, 2017 4:52 pm
Author: zed1015
Z1000 "1015" block wanted.
Bore size/condition doesn't matter as I only need the bare block to re-sleeve.

Re: Want 1015 barrels or liner 71mm max bore.

Posted: Mon Mar 13, 2017 5:21 pm
Author: Swirl
Have got some 71mm forged pistons and rings

Re: Want 1015 barrels or liner 71mm max bore.

Posted: Mon Mar 13, 2017 5:52 pm
Author: zed1015
Thanks but don't need pistons, just a bare 1015 block to re-sleeve.

Re: Z1000 (1015) bare barrel WANTED any size...

Posted: Tue Aug 08, 2017 11:25 am
Author: zed1015
Bump.

Re: Z1000 (1015) bare barrel WANTED any size...

Posted: Tue Aug 08, 2017 4:48 pm
Author: neilbarrett

Re: Z1000 (1015) bare barrel WANTED any size...

Posted: Tue Aug 08, 2017 6:59 pm
Author: zed1015
neilbarrett wrote:http://www.ebay.co.uk/itm/Kawasaki-Z1000-Cylinder-Barrel-Z900/372032376919?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m1438.l2649

Already watching that and undecided due to the fin bashing on both ends of the block where they have had a go with the mallet..
Wouldn't have been so bad if it were anywhere else.

Re: Z1000 (1015) bare barrel WANTED any size...

Posted: Sat Aug 12, 2017 1:36 pm
Author: paul doran
I have a block

Re: Z1000 (1015) bare barrel WANTED any size...

Posted: Tue Oct 10, 2017 12:51 pm
Author: Ultim8pc
If you're not sorted I have a selection of 1015 blocks.