Z1OwnersClub GB

This is probably a bit of a long shot but I need a cable bracket for a set of vm26 carbs. The set I have came from an early GS850 where the push cable mount is a good 15 to 20mm higher. As a result either the inner cable needs to be longer or the outer needs to be shorter by the same amount.
This is what I've got

and this is something like what I want


Thanks

Paul

Think you might find it easier to find a suitable cable than mount.

You'r probably right. If only my welding skills were as good as my photoshop skills.

I might have one be Friday before I can look

These two look like the lower one...

http://www.ebay.com/itm/Kawasaki-KZ1000 ... H0&vxp=mtr

http://www.ebay.com/itm/Kawasaki-KZ-650 ... mv&vxp=mtr

This looks like the tall one you have..

http://www.ebay.com/itm/77-83-Kawasaki- ... 56&vxp=mtr