Points Plate Grommet

[Niall M.]

Hi All,

Looking for the grommet that's on the points plate cable that goes to the coils,there's a slot in the casing where it sits this is for a Z1A but I assume there the same across the Z range.

Thank's,

Niall.

[000zeds]

Niall I might have one will look tomorrow

Have you tried Paul Doran

[Niall M.]

Thank you 000ZEDS.

[000zeds]

Niall I am sorry but no luck,

Try Paul Doran

[Niall M.]

Will do thank's for looking.

Niall.

[Kev1R]

The grommet in question appears to have an odd shape in that it has a flat side and is 'D' shaped.
Just a suggestion -
I suppose until one turns up, you could use a 'normal' round (maybe slightly undersize) one with a smear of silicon which should seal against the elements ok.
At least it would allow use of the bike without fear of water ingress knocking the ignition out.

[Niall M.]

Kev,as you said it's D shaped hopefully one will turn up as the Z1A is a restoration project but nearly there now just the carbs and wiring harness to fit and we'll see how it goes,thank you for your suggestion.

Niall.

[Bill P]

Ive previously cut one out of rubber to shape , seem to remember the hole was a pain in the arse .
got a few points set up now i've removed for electronic ignition so will have a look for one

[Niall M.]

Thank's Bill.

Niall.

[73z1]

21029-024 https://www.ebay.co.uk/sch/i.html?_osac ... 4&_sacat=0

[Niall M.]

Thank you 73z1 it's an option if a grommet dose'nt turn up.

Niall.

[Niall M.]

All sorted now thanks to Bill P a gent,and Thank you to ALL who make suggestions/options.

Have a good Easter in whatever shape or form.

Niall.