Page 1 of 1
Z1000/ z1r 28mm carbs
Posted: Thu Aug 25, 2022 8:25 am
Author: Hobbo
Guys
As title says after a tidy set of 28mm carbs to fit z1000 a1/a2
Not bothered about need bit of cleaning but not knackered ones
Plus can't afford mint restored ones
Phil
Re: Z1000/ z1r 28mm carbs
Posted: Sun Aug 28, 2022 7:02 pm
Author: tightwad
are these any good, they are 28mm carbs, not sure if z1r but i put new keyster kits in to suit z1r and choke plungers have been done by rob meggit. choke holding screw is missing. looking for £250
ken
Re: Z1000/ z1r 28mm carbs
Posted: Mon Aug 29, 2022 10:35 am
Author: Hobbo
Hi thanks for that I have just paid for some this morning but will keep details
Thanks
Re: Z1000/ z1r 28mm carbs
Posted: Mon Aug 29, 2022 10:35 am
Author: Hobbo
Guys
Prob sorted now thanks
Phil
Re: Z1000/ z1r 28mm carbs
Posted: Mon Aug 29, 2022 6:09 pm
Author: tightwad
no worries, i did measure them to make sure they were 28mm and they are 29mm
ken
Re: Z1000/ z1r 28mm carbs
Posted: Mon Aug 29, 2022 6:29 pm
Author: zed1015
tightwad wrote:no worries, i did measure them to make sure they were 28mm and they are 29mm
ken
No! They are 28mm.
They are sized by the width at the narrowest point in the venturi which is usually the bore closest to the needle jet.
The venturi tapers out toward the outlet so vm26 measure around 27mm and vm28 around 29mm at that point.
Re: Z1000/ z1r 28mm carbs
Posted: Tue Aug 30, 2022 6:50 pm
Author: tightwad
thanks for the explanation, never thought of them being tapered
ken
Re: Z1000/ z1r 28mm carbs
Posted: Thu Sep 01, 2022 12:45 pm
Author: walshyco
Interested, PM sent.