Trying to raise the needle from clip position 2 (from the top) to position 3, my problem is that the needle now sticks up above the top of the slide a bit more, as you would expect, the trouble is the part that then screws down onto the slide fouls the top of the needle and doesn't operate smoothly, stopping the slide from returning.
If I put the clip back to position 2 it works fine again?
I've read that as standard Z's and Z1a's should be on 3 anyway and Z1b's often need to be put on 3 so why am I having problems, they are brand new Mikuni Needles and Needle jets bought from Allens just last week.
Any pointers much appreciated.
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Problem raising needles Z1b.........
Moderators: chrisu, paul doran, Taffus, KeithZ1R
Re: Problem raising needles Z1b.........
Paul, compare the new needles with the repro ones that came out,and or put old needles back on pos 2 then pos 3....
PAULJAC47,,,,,"She may not look like much, but she's got it where it counts, kid."
-Han Solo
You can't polish a turd, but you can roll it in glitter
Salad is what real food eats.
Anon
PUM 673
-Han Solo
You can't polish a turd, but you can roll it in glitter
Salad is what real food eats.
Anon
PUM 673
Who is online
Users browsing this forum: No registered users and 38 guests