Hi All,
Does anyone have experience with setting up standard VM carbs with pod filters and 4 into 1 pipe like a Harris etc?
Ideally looking for appropriate sizes of:
Main jet
Pilot jet
Air screw setting
Needle number
Needle height setting
If any mods are required on main air jet etc.
Capacity is 1105 with 10.3:1 CR. Although as a starting point standard capacity motor settings would be fine.
Thanks in advance....
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
VM carbs with pod filter setup
Moderators: chrisu, paul doran, Taffus, KeithZ1R
- Zomerset Zed
- 100Club
- Posts: 239
- Joined: 30th May 2014
- Location: Somerset
Re: VM carbs with pod filter setup
Not me but it might be helpful to others to know what size VM's?
- Zomerset Zed
- 100Club
- Posts: 239
- Joined: 30th May 2014
- Location: Somerset
Re: VM carbs with pod filter setup
Not me but it might be helpful to others to know what size VM's?
Standard, as in 26's
Who is online
Users browsing this forum: No registered users and 122 guests