Hello Guest User,

Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.

To access these 'Registered Users Only' areas simply register and login.

Ideas

Need help restoring, building, or finding then try here.

Moderators: paul doran, Taffus, KeithZ1R, chrisu

Post Reply
Message
Author
User avatar
BShaw
Area Rep.
Area Rep.
Posts: 455
Joined: 22nd Dec 2001
Location: Westgate on sea

Ideas

#1 PostAuthor: BShaw » Wed Jun 10, 2009 4:00 pm

Any ideas, my Zed has been running rough on tick over and up till about 1/3 throttle (well it seems ok after that anyway), I have traced it to #2 cylinder. I have swapped plugs, cleaned pilot jets and swapped leads, I have a good spark, obviously I can't guarantee that the pilots are cleaned properly as I have no kit, but before I start buying things I thought I would have a punt on here. Carbs are RS36's BTW, I have electronic ignition and have tried a mix of new and old plugs... What do you lot think.
Regards
Baza

I had the day off from school when we did inglish.
Top
PaulMceleney
Chunks
Posts: 568
Joined: 29th Jan 2008
Location: milton keynes

#2 PostAuthor: PaulMceleney » Wed Jun 10, 2009 4:54 pm

have a look at your mainfold rubbers swap them over to see if there is any changes
Top
StephenW
100Club
100Club
Posts: 190
Joined: 8th Dec 2006
Location: Latchingdon, Essesx

Same thing

#3 PostAuthor: StephenW » Thu Jun 11, 2009 7:19 am

Hi
Just traced the same fault with my Z1R.
It was damaged manifold rubbers on 3 & 4
Replaced with new rubbers and clips.
Job done.

Good luck
Top
User avatar
BShaw
Area Rep.
Area Rep.
Posts: 455
Joined: 22nd Dec 2001
Location: Westgate on sea

#4 PostAuthor: BShaw » Thu Jun 11, 2009 11:52 am

Cheers troops, will give that a go... will be next week now before I get a chance... seemed odd though , good spark and wet plug.
Regards
Baza



I had the day off from school when we did inglish.
Top
User avatar
floydsz1
Hardcore
Hardcore
Posts: 1421
Joined: 24th Jun 2007
Location: SUNNY MORECAMBE

#5 PostAuthor: floydsz1 » Thu Jun 11, 2009 5:14 pm

Baza, could be running weak on that cylinder. while its running squirt some wd40 around the rubber manifold and see if the revs rise, that indicates its drawing in air.
peter.
Top
Post Reply

Return to “Bike Help”

Who is online

Users browsing this forum: No registered users and 174 guests