Hi,
My z1000 dropped onto 2 cylinders this morning, coil was a bit melted so replaced it with one from Z Power. New coil is by EMGO.
Fitted the coil but still no spark.
What fault does the melted coil point to?
Thanks, John.
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Melted coil!
Moderators: paul doran, Taffus, KeithZ1R, chrisu
Check power getting to low tension side and if it is measure primary and seconary resistance of coil to see if it matches your good coil if still on points check gap and condensor see if you get spark when you open points with ignition on,melted coil may indicate insulation breakdown....Cheers Paul J...
PAULJAC47,,,,,"She may not look like much, but she's got it where it counts, kid."
-Han Solo
You can't polish a turd, but you can roll it in glitter
Salad is what real food eats.
Anon
PUM 673
-Han Solo
You can't polish a turd, but you can roll it in glitter
Salad is what real food eats.
Anon
PUM 673
Who is online
Users browsing this forum: No registered users and 94 guests