Page 1 of 1
Inlet Rubbers
Posted: Sat Jul 30, 2011 12:50 pm
Author: Muddychris
Think i know the answer to this one but
To fit new inlet rubbers on a gpz1100 A1. Do I have to use anything to seal them or as I would assume just make sure the head surface is clean and bolt them straight on?
Cheers
Chris
Posted: Sat Jul 30, 2011 2:40 pm
Author: Mark Tiller
I would use a smear of blue hylomar
Posted: Sat Jul 30, 2011 3:57 pm
Author: jimmock
Mark Tiller wrote:I would use a smear of blue hylomar
I just love that word "smear" !!
Jimmock.
Posted: Sat Jul 30, 2011 7:51 pm
Author: kev edwards
You should not need to as long as the manifold faces are good.
and jim you are a depraved puppy, but you entertain.
Posted: Thu Aug 04, 2011 11:11 pm
Author: jimmock
kev edwards wrote:You should not need to as long as the manifold faces are good.
and jim you are a depraved puppy, but you entertain.
Kev, how the hell did you find out about the puppy thing??
Jimmock.