Page 1 of 1
starter clutch
Posted: Tue Oct 09, 2012 4:11 pm
Author: sme
how do i get the starter clutch off the end of the crank?
i have taken the small bolt that holds it on,
just need to get it off so i can check the bits
Posted: Tue Oct 09, 2012 5:44 pm
Author: z1bman
use the centre bolt from the top yoke to remove the rotor if you don't have the proper puller
Posted: Tue Oct 09, 2012 6:00 pm
Author: Pigford
.........also the rear wheel axle fits too = apparently
Posted: Tue Oct 09, 2012 6:16 pm
Author: 750steve
Pigford wrote:.........also the rear wheel axle fits too = apparently
Yip, a 20mm axle works too. Did on my GPz750 engine & Z750B Twin Engine. Havent tried the 650 yet