Z1-R side panel badges - dimensional positioning

Ed Z1-R · #1 PostAuthor: **Ed Z1-R** » Sat May 20, 2006 2:10 am

could anybody give me the dimensional positioning of the badge onto the side panels? THANX.

debben1 · #2 PostAuthor: **debben1** » Sat May 20, 2006 5:54 pm

Hello Ed, I will measure my old sidepanels on Monday, think I have an original set in the roof somewhere, Regards, Steve

Ed Z1-R · #3 PostAuthor: **Ed Z1-R** » Mon May 22, 2006 10:44 pm

Thanx steve thats most appreciated

debben1 · #4 PostAuthor: **debben1** » Wed May 24, 2006 12:07 pm

Hello Ed, bottom of badge is 170mm from bottom of sidepanel, 65mm from front edge of panel(measured parallel)to front edge, Steve

#5 PostAuthor: **chrisu** » Wed May 24, 2006 12:41 pm

ed,

let me know if you want a hi-re digital picture of sidepanel. I took loads of pics during my rebuild.

Ed Z1-R · #6 PostAuthor: **Ed Z1-R** » Fri May 26, 2006 1:53 am

Gentlemen thankyou for your help,its much appreciated.