Z1OwnersClub GB

Posted: **Fri May 03, 2013 6:04 pm**

Has anyone had any issues with fitting K&N type Engine breather :oops:

Posted: **Fri May 03, 2013 8:57 pm**

Rick,

Only problem I had was fitting one too low, with an APE breather cover without baffles. :shock:

It was fine whilst taking things steady, but once I gave it 'the beans' the oil couldn't get out fast enough. :evil:

Solved the problem by fitting a taller pipe, similar to the one in your pic.

Posted: **Sun May 05, 2013 11:44 am**

did the same with a halfords filter,but dropped a ball bearing in like t section pipe to act as a one way valve to help solidify oil mist back to chamber.

Not sure yet if its helping with my total oil loss i seem to be having,as it was an open air system prior