Wheel spacer
Posted: Thu Oct 24, 2013 3:54 pm
I would welcome suggestions as to the easiest and best way to space the front wheel on my project.
Option A: Weld a 6mm thick washer to the outside of the existing spacer.
Option B: Fabricate a new spacer. (It is 40mm at its largest diameter).
This is the existing spacer. What do you think?
Option A: Weld a 6mm thick washer to the outside of the existing spacer.
Option B: Fabricate a new spacer. (It is 40mm at its largest diameter).
This is the existing spacer. What do you think?
