Z1OwnersClub GB

Guyz anyone know a source in the Uk for kits to convert 630 to 530 chains(Suzuki Gs1000)??

Z1 enterprises list (I know its not UK - but does give you the sprocket references).

http://www.z1enterprises.com/ListItems. ... 1309010000

You need a JTR816 rear sprocket. List of models in this link.
http://www.jtsprockets.com/catalogue/sprocket/JTR816

Then you need a JTF513 front sprocket.
Probably the 18 tooth of a 1250 bandit would be best.
http://www.jtsprockets.com/catalogue

The go buy something like a 120 link chain and chop off what you don't need.

Debben performance do all the kits ,i just done my uni-trak , Talon rear, sprocket gold ,and top of the range DID also gold ,bike feels loads smoother and gear change has got better ,more precise . cost a bit more than a standard set up ,but i think most big bikes run 530 now ?

Ta Lads

Sorry for the lateness of my reply.
I wanted to mention about the locking tab-washer. Not sure what they have on the Suzuki, however every 530 front sprocket I've purchased has two 6mm screw holes at a different PCD than the usual small tab-hole.
I usually make up a tab washer as per pic.


I used to make them out of sheet stainless until I stuffed my hole saw!
RegardZ.

"until I stuffed my hole saw"

Dirty sod...no wonder it ran away