A2 SPROX
Posted: Fri Dec 04, 2015 5:35 pm
Guyz what teeth standard should a 78 a2 be running sprox front and rear?
Page 1 of 1
Posted: Fri Dec 04, 2015 6:06 pm
Ok found out 15t front 33 rear,35 teeth rear as option anyone tried that option? guess you lose top end and gain acceleration?
Posted: Fri Dec 04, 2015 6:59 pm
Hi Paul,
Most Jap bikes are 1 tooth to big on the front (aprox 3 teeth on the back).
The way I do it is to setup the gearing so that I am just off the redline in top flat out.
I was going a bit quick on a zx12r to get it right but it's apart of the fun right
For any PC plods on here I was on a closed road honest he he.
Most Jap bikes are 1 tooth to big on the front (aprox 3 teeth on the back).
The way I do it is to setup the gearing so that I am just off the redline in top flat out.
I was going a bit quick on a zx12r to get it right but it's apart of the fun right
For any PC plods on here I was on a closed road honest he he.
Posted: Sat Dec 05, 2015 9:44 am
http://www3.telus.net/shebang/sprocket_calculator.html
this is a good tool
15 t 33t gives 0.4545 on the back
15 t 35t gives 0.4285 on the back
this is a good tool
15 t 33t gives 0.4545 on the back
15 t 35t gives 0.4285 on the back