Page 1 of 1
Minor Engineering Job
Posted: Sun Feb 19, 2017 11:41 am
Author: Fred the Zed
Anyone know of an engineer in North / Central Birmingham who can do a small machining job for me?
I just need the rear axle cross-drilling for a split pin.
Fred
Posted: Sun Feb 19, 2017 8:08 pm
Author: sid123
Have you got a pillar drill ? if so use a v block -- if not I can do it for you while you wait ( jcn2 m5 ) you can point out where you want it drilling and watch it being done
Posted: Sun Feb 19, 2017 8:27 pm
Author: Fred the Zed
PM sent
Thanks
Posted: Sat Feb 25, 2017 4:28 pm
Author: Fred the Zed
Many thanks to SID123 for helping me out with a bit of machining today.
Top bloke
All the best
Fred
result
Posted: Sat Feb 25, 2017 8:13 pm
Author: 8 Valve Mark
z1oc,where else can you nick round to a stranger's shed and be happy to have him drill you a new hole??
result
Posted: Sat Feb 25, 2017 8:31 pm
Author: 8 Valve Mark
z1oc,where else can you nick round to a stranger's shed and be happy to have him drill you a new hole??
Posted: Sat Feb 25, 2017 8:58 pm
Author: sid123
Ask Fred the Zed - I made sure it was lubed properly before giving a good drilling
Posted: Sun Feb 26, 2017 3:59 pm
Author: Fred the Zed
I never felt a thing.