Page 1 of 1
Stator wiring problem
Posted: Mon Jun 12, 2017 10:19 am
Author: Jacko
Hi guys, got a new stator for my Z1000A1 and the Oil pressure switch and neutral have round connectors instead of the original right angled connector. Anyone know where I can can the right angle connectors from?
Cheers
Re: Stator wiring problem
Posted: Mon Jun 12, 2017 11:44 am
Author: warren3200gt
You could try this place, I dont recall seeing them on their website but could be tucked away someplace.
http://www.vehicle-wiring-products.eu/p ... sq-28-0-30
Re: Stator wiring problem
Posted: Mon Jun 12, 2017 12:38 pm
Author: Jacko
Cheers Warren, I've checked it out and they don't have them. Just wondering how other folk have sorted this problem out, I feel I shouldn't have to cut the old ones off and wire them to the new wires. I can't figure out why these stators are supplied with the incorrect connectors. I've looked at a few on the internet and they all have the same round flat connectors.
Re: Stator wiring problem
Posted: Mon Jun 12, 2017 12:41 pm
Author: warren3200gt
I can see some female soldered bullet connectors bent at 90 deg and heat shrink sleeve coming on.
Re: Stator wiring problem
Posted: Mon Jun 12, 2017 2:33 pm
Author: zed1015
10 seconds on google found all you need and loads more Jap bike connectors .
http://kojaycat.co.uk/Connectors-Bullet ... Connectors
Re: Stator wiring problem
Posted: Mon Jun 12, 2017 2:51 pm
Author: HowieD
'kin hell been looking for ages to find them - searched on the propper name though - Post Connector !!
How about the plastic covers to go over them as well ???
Re: Stator wiring problem
Posted: Mon Jun 12, 2017 4:45 pm
Author: Jacko
Jeez! Thanks for that. I spent ages Googling and couldn't find them, just not using the right words i suppose. Cheers for that
Re: Stator wiring problem
Posted: Mon Jun 12, 2017 4:49 pm
Author: warren3200gt
What did you google to find that ? I googled 90 deg post connector and came up with aload of fence bits.
Good find, book marked for future ref!
Re: Stator wiring problem
Posted: Mon Jun 12, 2017 5:48 pm
Author: zed1015
warren3200gt wrote:What did you google to find that ? I googled 90 deg post connector and came up with aload of fence bits.
Good find, book marked for future ref!
Most common term is bullet connector so just searched "90 degree bullet connector" and got them on the first hit.
Re: Stator wiring problem
Posted: Mon Jun 12, 2017 8:24 pm
Author: HowieD
Bought a packet - don't need them right now but been looking long enough so mission accoumplished !!
.
.
.
.
as far as looking for Post Connectors as concerned.
Plus I am planningthe Mk8 Loom for Horace