Page 1 of 1
Front Master Cylinder Z1a
Posted: Mon Jul 31, 2017 6:03 pm
Author: BigZCas
Want to get this black anodized but not sure how to remove the innards
?
I have dismantled all except for the bit inside
Can anyone advise please
Cheers
Re: Front Master Cylinder Z1a
Posted: Tue Aug 01, 2017 6:35 am
Author: marmck
Re: Front Master Cylinder Z1a
Posted: Tue Aug 01, 2017 6:43 pm
Author: BigZCas
No, it's the insides.
I will have a go at following the Haynes manual later in the week.
Thanks
Re: Front Master Cylinder Z1a
Posted: Tue Aug 01, 2017 6:48 pm
Author: marmck
Have you tried YOU TUBE
Re: Front Master Cylinder Z1a
Posted: Tue Aug 01, 2017 6:54 pm
Author: swampy
You will need a set of right angled internal circlip pliers with very thin legs. You will also need a dowel of some sort to help pkoe the piston out from the banjo end if stiff.
Take a pic of the sequence the piston and gubbins come out. Then buy a new piston kit for the master cylinder for the reassembly. Do not attempt to use the old one.
Re: Front Master Cylinder Z1a
Posted: Tue Aug 01, 2017 7:03 pm
Author: BigZCas
