VM carbs with pod filter setup
Posted: Tue Nov 28, 2017 1:47 pm
Hi All,
Does anyone have experience with setting up standard VM carbs with pod filters and 4 into 1 pipe like a Harris etc?
Ideally looking for appropriate sizes of:
Main jet
Pilot jet
Air screw setting
Needle number
Needle height setting
If any mods are required on main air jet etc.
Capacity is 1105 with 10.3:1 CR. Although as a starting point standard capacity motor settings would be fine.
Thanks in advance....
Does anyone have experience with setting up standard VM carbs with pod filters and 4 into 1 pipe like a Harris etc?
Ideally looking for appropriate sizes of:
Main jet
Pilot jet
Air screw setting
Needle number
Needle height setting
If any mods are required on main air jet etc.
Capacity is 1105 with 10.3:1 CR. Although as a starting point standard capacity motor settings would be fine.
Thanks in advance....