Z1OwnersClub GB

I'm going to reassemble my engine soon following having the cases vapour blasted and was wondering what sealant is recommended for the top to bottom case joint?

I have some ThreeBond TB1215 grey silicone sealant but am not sure if this is the best thing to use. I've also heard of ThreeBond 1105B a.k.a. Kawabond and also MIchel semi-drying gasket cement.

Any recommendations from people who have been there and done this?

Thanks in advance, Rob

This - https://www.ebay.co.uk/sch/i.html?_from ... tv&_sop=15

I've used the Michel gasket cement on my GPz crankcase joints with no problems.

always used kawabond or yamabond or the maker equivalent. never had a problem.

Had some Three Bond left after the Kettle rebuild and that worked a treat, so i used it again in my A4 re build,
shouldn't be a problem, more or less doing the same job.

Black Loctite sealant from Halfords

zed1015 wrote:This - https://www.ebay.co.uk/sch/i.html?_from ... tv&_sop=15

+1

Thanks for the replies.

I was wondering if I should use a silicone type that cures (like V-Tech or Threebond 1200 type) or a semi-drying type (like Threebond 1100 or Michel).

It seems that people have used both types successfully on cases so I'm probably over thinking it and will just use the Threebond 1215 silver sealant that I already have.

Cheers,

Rob

Robw wrote:Black Loctite sealant from Halfords

Yep.

I thought this was the best stuff to use :
https://www.ebay.co.uk/itm/STAG-WELLSEA ... SwNf1ZtiT8

foz

FOZ1A wrote:I thought this was the best stuff to use :
https://www.ebay.co.uk/itm/STAG-WELLSEA ... SwNf1ZtiT8

foz

Yeah, that was recommended to me too by a mate who rebuilds his (car) racing engine regularly.

Kawabond every time. Make sure mating faces are fully
degreased with something like brake/clutch cleaner.