Hi my mate has a z thou a2 which he has converted to the double disc set up
Is the master cylinder set up for this ? as he cant get a good brake or does it have to be a different master cylinder piston ? Looking on the z power site he says there are two lengths !
Thanks
Mark
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Z thou a2 brake prob
Moderators: chrisu, paul doran, Taffus, KeithZ1R
Z thou a2 brake prob
4 pipe a1, z1000 st ,gpz rx 1000 x3 , Rx bitza in boxes x1
Re: Z thou a2 brake prob
I think you would need a 5/8 master cylinder I am sure someone will correct me if it’s wrong
GPZ1100 A1 zrx1100 gsa1200
Re: Z thou a2 brake prob
GPZ1100 A1 zrx1100 gsa1200
Re: Z thou a2 brake prob
This a2 has a 4 sided standard master cylinder wider at one end than the other , I thought it was only the rounded type that caused a problem with the double disc ?
4 pipe a1, z1000 st ,gpz rx 1000 x3 , Rx bitza in boxes x1
Re: Z thou a2 brake prob
David Silvers, get one for a Cb750 f2,its exactly the same generic copy and usually cheaper.same ones are readily available on ebay as well,though round not squarish,or get the original bored out to 5/8.
PAULJAC47,,,,,"She may not look like much, but she's got it where it counts, kid."
-Han Solo
You can't polish a turd, but you can roll it in glitter
Salad is what real food eats.
Anon
PUM 673
-Han Solo
You can't polish a turd, but you can roll it in glitter
Salad is what real food eats.
Anon
PUM 673
Re: Z thou a2 brake prob
This would sort the problem, https://www.ebay.co.uk/itm/Kawasaki-Z-6 ... SwLlVamGCk
Re: Z thou a2 brake prob
Hi I have a leaking 14mm master cylinder on an A2 and the cylinder has a groove from corrosion.
Do you know where I could get it bored out to 5/8 inch?
I would prefer to keep it original if possible.
Do you know where I could get it bored out to 5/8 inch?
I would prefer to keep it original if possible.
Who is online
Users browsing this forum: No registered users and 48 guests