Clutch push rod info
Posted: Sun Apr 29, 2018 10:08 pm
Hello chaps,
I’ve seen somewhere that you can make a replacement clutch push rod from silver steel rod, is that right ? If so, can anyone tell me the sizes I need ? I think it’s 8mm ? But not sure of the length. It’s for a Z900 by the way.
If not, no worries, but I was hoping to make one up ready to fit before I dissemble it.
Cheers
Paul
I’ve seen somewhere that you can make a replacement clutch push rod from silver steel rod, is that right ? If so, can anyone tell me the sizes I need ? I think it’s 8mm ? But not sure of the length. It’s for a Z900 by the way.
If not, no worries, but I was hoping to make one up ready to fit before I dissemble it.
Cheers
Paul