Z1000 rear brake

[Tony(hank)harper]

Folks
This is the brake pedal on my thou registered as 1978 .
The V5 confirms the frame has been replaced with one without a dedicated Kawasaki number so I cannot be certain it is a MK2.
The diagram on Zpowers site differs as well so what have I got here?
Cheers.

[8 Valve Mark]

hi hank, i think maybe 77a1,its not a mk2 as they have a clevis/fork on the bottom of the push-rod, i think the 78a2 does too. someone will confirm I'm sure. mk2 came out later.(frame no. kztooae....) possibly 77 in a new 78 frame?? anypics, numbers etc.. m

[Philippe]

Hi
could it be a Z1R brake pedal ?
GrtZ
Philippe

[Tony(hank)harper]

Hi Philippe
the whole bike is a lash up hence the question.
Frame has been stamped DA347 in the usual place so no help at all.
looking like it's the wrong pedal.

[Philippe]

Hi
give us some more pictures, maybe that might help to determine the frame and other bits.
GrtZ
Philippe

[kev edwards]

Its not an A1, A2 or B2 brake pedal but does look like a Z1r pedal.

[Tony(hank)harper]

Yep
It definately looks Z1R, one on fleabay.
It will stay as it is for now
Thanks for the help.

[8 Valve Mark]

what's the engine number hank? if its kztoode.... that indicates a z1r, the brake pedal assembly supports the theory, the re-stamped frame D might lean towards z1r too?? can you add some more photos? cheers m

[Swirl]

This a new one Hank, or one from the back of the shed

[Tony(hank)harper]

Hi swirl.
Back of the shed. Whole thing is a complete lash up of bits and bobs. Bought it for engine, frame and z1B bodywork. Have spare front and rear 17" setup so was going to monoshock it.
Engine is a MK2 and was buggered so I've spent a ruck on rebuild. Got other projects as you know so just putting it back on the road as a complete bike for bimbling about on.

[Tony(hank)harper]

Folks
I am convinced it is the pedal. The pivot is roughly 63mm long but the pedal 56mm as the picture shows. I expect if a Z1000 A1/2 pedal is measured it will be 63ish