Page 1 of 1
GPZ1100 B1 vs. Z1 range frame dimensions
Posted: Thu Apr 25, 2019 2:33 am
Author: Jay1969
Hi everyone.
Are the centre stand lugs, the rear engine mountings,
and swing arm width the same widths apart on these 2 frames?
Re: GPZ1100 B1 vs. Z1 range frame dimensions
Posted: Thu Apr 25, 2019 8:48 am
Author: chrisNI
Hi Jay nice to see you’re back.
Without getting the tape measure out I’d guess the answer is no.
Re: GPZ1100 B1 vs. Z1 range frame dimensions
Posted: Fri Apr 26, 2019 6:40 pm
Author: 8 Valve Mark
what's the cunning plan jay? centre stand mounts are different both ways i reckon but I've seen plenty of gpz/j motors in Z frames. anything goes as they say!! ps swinging arms are very close, so should be feasible m
Re: GPZ1100 B1 vs. Z1 range frame dimensions
Posted: Fri Apr 26, 2019 8:06 pm
Author: neilbarrett
gpz motor is shorter,you end up with a gap were the kick start used to be