Z1OwnersClub GB

I'm restoring a Z900A4 for a guy who would like two paint sets...one in standard A4 colours using an A4 tank and one in early Z1 brown and orange.

For the early paint set, I was wondering if we could use one of the reproduction petrol tanks (PMC or Doremi) but I'm not sure if and how well it will fit onto a Z900 frame...has anyone else tried this?

Thanks,
Steve

I have an early tank i can dig out and try on my z1000a1 frame if no-one knows, i think a4 1000 frames are the same

Tank and tail should be ok but z1 side panels will need bit of alteration

Phil

Or just use another z900 bodyset and paint and badge accordingly.

what phil said.

also what rear light are you going to use - square or oval ?

Doremi sell z900 tanks/panels etc. painted in Z1 colours.

the onlt issues you have with swapping round tanks is that the fuel tap can foul on the carbs.

Can't remember which way round it was though.

Thanks all for your replies.

It's only the tank we are concerned with...the side panels and tailpiece will remain as the A4 type for both paint sets. Using a Z1 repro tank is just an option as it comes ready painted, but I just needed to know if it fits the Z900 frame. Oddly enough, we have already tried to fit a new unpainted repro A4 tank (not sure who made this) but it was too narrow at the front and wouldn't slide onto the two front rubbers...and didn't want to force it.

Of course, our other option would be to find another used A4 tank, panels and tail piece and re-paint as Ultim8pc has suggested.

Thanks, Steve

Strange one there as my Z1B had a Z900 frame and I don`t remember any problems with fitting the tank!

I have a z1a tank on my z1000a1 it is a bit of a wriggle but I put that that down to new rubbers pingle tap fits ok as well

That's useful to know...cheers guys

Z1 tank fits Z900 frame.

I had a Z1 tank that came on my wrong clothes Z1R

On looking at it against the z900 tank it's shorter in length so the seat sits with s gap

I believe that a z1000 a1 is s perfect fit on the the z900a4

But not the z1000a2 as pet cocks are vacuum with different fitting

I could look into this more as I have z900a4, z1000a1and a MK2 with a thought to be z1000a2 tank on it which I was hopeing to see if it fits the z900a4 as would like two paint sets for Z900a4

000zeds wrote:Strange one there as my Z1B had a Z900 frame and I don`t remember any problems with fitting the tank!

Isn't a Z1B with a Z900 frame a Z900 with Z1B parts?