Page 1 of 1
Fitting main loom
Posted: Sat Jun 13, 2020 10:34 am
Author: Adrian90s
Hi guys
Fitting a new main loom (already have new L/R handlebar switches with harnesses), halfway down the loom is a 3-pin plug, where does that go?
Does any of the plugs go in the headlamp?
Where does the clocks wires go?
Silly questions I know...should have taken pictures
Ady
Re: Fitting main loom
Posted: Sat Jun 13, 2020 2:56 pm
Author: CAT3
What model are we refitting this loom to ?
Re: Fitting main loom
Posted: Sat Jun 13, 2020 4:17 pm
Author: Adrian90s
Hi,
Its a 1973 Z1 (usa), I have some progress, ignition on neutral and oil light, horn supply and starter turns engine.
Missing are indicators..
Lights
Clock back-light
Should I have a light flasher?
Re: Fitting main loom
Posted: Sat Jun 13, 2020 4:59 pm
Author: CAT3
To be honest, my expertise is on the A4's, not the earlier Z1's.
If you could post some pictures of where you are up to with the loom & any uncertainties you have I am sure the will be plenty of earlier Z1, A's & B experts only too willing to offer advice.
Re: Fitting main loom
Posted: Sat Jun 13, 2020 5:16 pm
Author: DavidZ1R
The three pin plug probably the brake outage switch.
Re: Fitting main loom
Posted: Sat Jun 13, 2020 10:30 pm
Author: engz1b
indicator wires green left side, grey right side, and earth wires black with yellow stripe.(front and back) wires for indicator relay , one is brown, and one is orange, (near the battery) back light for clocks ,blue wire , and black with yellow stripe (earth)
Re: Fitting main loom
Posted: Sat Jun 13, 2020 10:51 pm
Author: Adrian90s
Thanks guys
Re: Fitting main loom
Posted: Sun Jun 14, 2020 11:34 am
Author: Adrian90s
3-pin plug is brake failure ( Canada only)