Quiet at the back.
One of my rear pegs is refusing to stay up when told. Does anyone know if there’s an easy fix for this? Z-Power sell pattern replacements for £20 the pair, but I’d rather fix than replace if possible.
Ta.
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
I’ve got a floppy peg
Moderators: paul doran, Taffus, KeithZ1R, chrisu
I’ve got a floppy peg
1976 z900 A4 -- Now, with a little help from Wiseco and Steve Debben, it's a 1048 with rs34 flatsides
- warren3200gt
- Hardcore
- Posts: 2739
- Joined: 13th Jun 2014
- Location: Dartford Kent
Re: I’ve got a floppy peg
You need to put a thicker washer on it or a washer if you dont have any, Pablo. Sounds like the corners of the peg mount have worn and the peg rubber is no longer acting as enough of a spring against the mount.
Also give the end of the rubber a few whacks with a rubber mallet to ensure its not come off the metal peg which would have the same effect as above.
Also give the end of the rubber a few whacks with a rubber mallet to ensure its not come off the metal peg which would have the same effect as above.
Last edited by warren3200gt on Fri Jun 19, 2020 4:27 pm, edited 1 time in total.
PUM 488 June 2023
76 Z900A4, 77 Z650B1, 77 KZ650B1, 77 Z1000A1, 82 Z1000J2, ZRX1100R.
76 Z900A4, 77 Z650B1, 77 KZ650B1, 77 Z1000A1, 82 Z1000J2, ZRX1100R.
Re: I’ve got a floppy peg
Failing that, squeeze the mounting ears together a bit so it holds it tightly in place.
And on the 7th day... Zeds were created!
Re: I’ve got a floppy peg
Thanks guys - just got around to having a look at it.
Couldn’t find another washer of the same size (ID 25, OD 30) So fabricated one out of foam rubber packing material I had lying around. Does the job short term, but the bracket and pin have worn each other out pretty impressively so I think I might have to go for new replacement.
Unless anyone has a good pair knocking about?
Couldn’t find another washer of the same size (ID 25, OD 30) So fabricated one out of foam rubber packing material I had lying around. Does the job short term, but the bracket and pin have worn each other out pretty impressively so I think I might have to go for new replacement.
Unless anyone has a good pair knocking about?
1976 z900 A4 -- Now, with a little help from Wiseco and Steve Debben, it's a 1048 with rs34 flatsides
Who is online
Users browsing this forum: No registered users and 134 guests