Z1OwnersClub GB

All of the replacement and pattern handle bar grips seem to be 125mm which is 5-10mm too short for the standard Z1000A2 bars. Is there somewhere which sells grips which would be suitable?

cut 10mm off the handlebars

z1bman wrote:cut 10mm off the handlebars

The thought did very briefly cross my mind, but there must be a better way

try webike japan

https://japan.webike.net/bm/top/Grips/1031/

A lot of the repro stuff is getting shoddy
Think you can still get genuine left side but not sure of the right?

Thanks for all the replies. It seem that a lot of parts specialists?? sell the 125mm grips as suitable. They are definitely too short for the Z1000. Not sure about other models.

Z-Power have them,

Genuine http://www.z-power.co.uk/handle-bar-grips-pair-genuine

Pattern http://www.z-power.co.uk/handle-bar-grips-pair-pattern

000zeds wrote:Z-Power have them,

Genuine http://www.z-power.co.uk/handle-bar-grips-pair-genuine

Pattern http://www.z-power.co.uk/handle-bar-grips-pair-pattern

How did I miss that! Just spent loads on parts from Z Power.