Z1OwnersClub GB

Any one advise who to send my crankshaft to it need a new rod its a gpz1100 shaft with 18 mm pins
Ray Deben did my last one but he's off at the moment
Is anyone out there as good?

probably cheaper to buy this as its like new & only done 10k ? it would probably cost you £60 in return postage to send it to sep

https://www.ebay.co.uk/itm/kawasaki-z11 ... ition=3000

Due to my own personal experiences with SEP, I wouldn't trust them one bit.
They repeatedly lie and the workmanship is not much better. The worst company I have ever had the mispleasure to deal with ever.
Personally I would go to Chris Applebee, one of the best there is.

I used SEP years ago to do a zzr1100 crank and they were great.

Used them more recently to make a liner and they took many months to admit they didn't have the material. In the end they got the job done and didn't balls it up. A mate of mine who ran a workshop till recently had no end of trouble with them over some head repair that they bolloxed up.

Buzzard has sorted me a head rebuild and a rebore more recently and done a fine job both times. He's who I'd ask 1st from now on.

Olly

Thanks all I rang Appleby today had a long chat very impressed with the call so I'm sending it next week

Hi Si, I had Chris do my last 1000a1 crank had to have new rods, big ends, index, balance and weld. The bike now has hardly any vibration and I did not fall off the chair when the bill came through either.

Great thanks I rang Ray Debben he did it last time but he only sends them to Chris
Ill post it off Monday