Z1OwnersClub GB

Posted: **Mon Apr 05, 2021 1:33 pm**

Hi guys
I have just noticed on No. 4 carb,one of the overflow tubes has cracked inside the chamber where it enters the casting, are these tubes available from anywhere or is it a new chamber required, unfortunately it is off a set of pumper carbs so is slightly different

Cheers
Gavin

Posted: **Mon Apr 05, 2021 1:59 pm**

clean it up, and solder the crack :up

Posted: **Mon Apr 05, 2021 2:01 pm**

KeithZ1R wrote:clean it up, and solder the crack

What he said, if they're brass they should solder.

Posted: **Tue Apr 06, 2021 2:20 pm**

Cheers Keith & Garry,
It was cracked just below the point it enters the aluminium body, had a couple of tries with no success then decided the open the crack up a little and put lots of solder in, then drilled the tube clear of solder,
Jobs a good un it doesn’t leak.

Z1OwnersClub GB

Z1000 float chamber issue

Z1000 float chamber issue

Re: Z1000 float chamber issue

Re: Z1000 float chamber issue

Re: Z1000 float chamber issue