Evening all,
I've just assembled the crankcase on my Z900 A4. It all appeared to go well although I wasn't quite sure how far to extend the sealant on the flanges but just applied common sense. Strangely no manual seems to cover this in any detail. Anyway, there was an instruction to apply threadlock and sealant to the two outer (main crankshaft) 8mm bolts (numbers 6 and 8 in the tightening sequence) but not 5 and 7? I couldn't see why 6 and 8 needed sealing but not required for the two forward set bolts 5 and 7. I would be grateful if anyone could let me know.
Hello Guest User,
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.
To access these 'Registered Users Only' areas simply register and login.
Crankcase bolts
Moderators: paul doran, Taffus, KeithZ1R, chrisu
Re: Crankcase bolts
Is it because the two that require sealing, their threaded holes break into an oil gallery, whereas the two that do not require sealing go into blind holes ?
Or something like that anyway !
Someone will know for certain & be along shortly no doubt !!
Or something like that anyway !
Someone will know for certain & be along shortly no doubt !!
Who is online
Users browsing this forum: No registered users and 77 guests