Show us Yours
Posted: Wed Mar 04, 2015 2:41 pm
Here's my A4 doing it's best to look like a Z1b
Here's my A4 doing it's best to look like a Z1b
Page 1 of 1
Here's my A4 doing it's best to look like a Z1b
Posted: Wed Mar 04, 2015 11:25 pm
That looks like an early style ducktail?
Posted: Thu Mar 05, 2015 5:51 pm
Could be or is it the smaller Z1b light making it look that way!
Posted: Wed Jan 04, 2017 1:49 pm
Hi,just looking through older posts,and spotted bike i built a few years back,USC451R. certainly still looking good. Neil. 
Posted: Wed Jan 04, 2017 9:33 pm
Z1Scot wrote:Hi,just looking through older posts,and spotted bike i built a few years back,USC451R. certainly still looking good. Neil.
Hi Neal bought this bike back in Jan 2014 in a part ex with an old commando that the seller wanted. She's still running sweet since your rebuild. Checked and shimmed valves last year and oil change, plugs etc. Was missing on left cyl when collected but found blocked pilot jet and a carb balance sorted that out. Also fitted dyna ignition. Only used on dry sunny days of course! May have to sell this year as have knee problems and she's quite a heavy beast compaired to my Fazer8! Fancy it back? ! Cheers Richard.
Posted: Fri Jan 06, 2017 3:00 pm
Hi.yes im glad bike running good,when i got bike it had a Z1000 engine fitted,that was beyond repair.so picked up low mileage 900 engine from John Browse. The engine was completely stripped,it got new cam chain and all rollers,valve seals and guides,new rings,and cam bearings.The wiring was shot,at the time the A4 harness was not available,so fitted new Z1B and modified it. I sold it with Lester alloys,and definitely looks better with spoked. I would love bike back but no room in garage,and wife would kill me ��.
It actually rode and handled better than my Z1B. But had to make choice,don't think you will have any trouble selling it. It was a complete nut and bolt strip down,anything that needed replaced was. Cheers,Neil.
It actually rode and handled better than my Z1B. But had to make choice,don't think you will have any trouble selling it. It was a complete nut and bolt strip down,anything that needed replaced was. Cheers,Neil.
Posted: Fri Jan 06, 2017 9:31 pm
I wouldn't mind 1st dibs on it 
Posted: Fri Jan 06, 2017 9:59 pm
Mowjoe wrote:Could be or is it the smaller Z1b light making it look that way!
Looks like the earlier one, A4 duck tail is different to fit the more square light.
Forks are also Z1000A2 but fitted the wrong way round
Posted: Sat Jan 07, 2017 8:58 am
It does look great. -Twin discs is a bonus too.
I would be tempted to go a stage further and fit z1b side panel badges.
I would be tempted to go a stage further and fit z1b side panel badges.