Hello Guest User,

Please feel free to have a look around the forum but be aware that as an unregistered guest you can't see all of it and you can't post.

To access these 'Registered Users Only' areas simply register and login.

Harris Build

Work in Progress

Moderators: KeithZ1R, chrisu, paul doran, Taffus

User avatar
Posts: 136
Joined: 4th Dec 2017
Location: Ossett

Re: Harris Build

#76 PostAuthor: Simonic » Fri Nov 09, 2018 5:59 pm

HowieD wrote:
cakeman wrote:
HowieD wrote:Yes indeed, very nice !!

where did you buy those HT Lead "spreaders"


I think Phil the previous owner made them. They look like a cable tie with a short piece of clear pipe between.

ah right - zoomed right in and can see that now. Thanks for the reply.


There's various different types available in the car world.I use them on the Dodge
'81 Z1000ST, '04 GSX1400, '71 Dodge Charger Superbee

Regular Poster
Posts: 55
Joined: 30th Jul 2018
Location: Staffordshire

Re: Harris Build

#77 PostAuthor: cakeman » Sat Dec 08, 2018 12:01 pm

No updates for a while but a little bit of progress made.
Changed the cut down Harris fairing for a half fairing purchased from Dynodave that he got from Ragged Edge, quality was ok apart from one edge where the fibreglass hadn't bonded to the gel coat and there was an air bubble that was about a foot long that had to be filled and shaped but turned out ok in the end and feels nice and solid now :)
Also splashed out on a set of flatslides as I think I may have had a few problems setting up the 34mm z1000j carbs I'd got so bit the bullet and picked up a set of 29's bored to 33 that hopefully will do the job.
Couple of pic's.

User avatar
Site Admin
Posts: 2364
Joined: 22nd Dec 2001
Location: NI

Re: Harris Build

#78 PostAuthor: chrisNI » Sun Dec 09, 2018 11:36 pm

Looks proper :D :D

Return to “Projects”

Who is online

Users browsing this forum: No registered users and 14 guests