Racecrafter

[Iain marshall]

Ed using the rear hub as they sometimes ran an alloy on the front and a wide spoked wheel on the rear plus the guy i bought the Morris alloys of seems to have had a problem reading a measuring tape,lets just say the rear wheel is not 3.5 ,there is a couple of your bits going on the bike Ed Thanks for the offer Davy,been doing a bit of practice on the welding front.Phil it was nice of you to let me have the oil cooler,even though you didnt know anything about it at the time Davy dont worry about Paulys kind words,the more he says the more he'll have to eat .Anyway all the luggs and extra brackets have been removed from the frame,the rear foot rest brackets have found a new home on someone elses frame.Spent a few hours the last few days cutting up a new H**** frame to make strengthening brackets for the Zed frame,pics next week

[paul doran]

get yer cleaning cloth ready

[Davy Doherty]

Iain, Any progress to report!!

[Iain marshall]

Davy i'll try and get some pics up tomorrow night,got some goodies off ebay tonight more about them later.Also been busy on an old Zed motor

[Iain marshall]

As usual the time flies in,been busy the last week but the frames done.Next problem is the wheels,do i go for this set up alloy front and wire rear



or alloy front and rear



replies on the back of ?20 notes to the usual address

[Padders]

Alloys front and rear.

padders

[Pigford]

Gotta be same each end, or it'll look like its botched even if they did race 'em like it

[Rich]

What plans have you got to drive the alternator - belt from crank - gearbox sprocket?

Will you be keeping that Monoshock arrangement

[Iain marshall]

Alternator,whats that for?there might be some sort of self generating system getting used .Rich what do you mean "Monoshock" i've got a pair of S+W shocks for it

[Davy Doherty]

Alloys F/R..

[Iain marshall]

Right thats it then,so whos got a nice 18x3/3.5 rear Morris alloy sitting in their shed looking for a good home??

[Rich]

can you get an alternator small enough to go in instead of the starter motor? Cut the cover down - toothed belt drive and use a kickstart. If I could get a kickstart on the Harris that's what I'd go for.

[Pigford]

Stop goading him Rich, he ain't gonna get rid of those ignition bits, its gonna be a token replica , nearly

[Rich]

Another unfinished project I imagine

[Iain marshall]

Wouldn't bet on it Rich,unless Jac see the invoices Mark what do you think of the carbs for the "token" replica